This Program Card allows you to change settings on HURC Electronic Speed Controls*. This card is very easy to use. You simply attach the receiver plug of ESC to the card, connect a battery to the ESC, then make your programming selections with a couple of buttons on the program card. An instruction sheet is included.
*This program card will work with HURC 7, 10, 22, 30 and 40 amp speed controls. It is not compatible with the 60, 80 and 100 amp OPTO speed controls. The 60, 80 and 100 amp OPTO speed controls can be programmed with a transmitter.
Here is a list of the programming options:
1. Motor brake: Off, On.
2. Battery type: Lithium or NiMh
3. Cut-off type: Soft or Hard
4. Cut-off voltage: Low, Middle, High
5. Start Mode: Normal, Soft, Very Soft
6. Timing Mode: Low, Middle, High
7. Tone Selection for Lipo Cell Count
8. Governor mode: Off, On
Programming buttons are up/down, left/right, select
|
e-Gift Cards
Wish List
